Each sludge conditioner product has a corresponding field and method of use. Only reasonable use can play the effect of this sludge conditioner. So the question is, what happens when there's too much sludge conditioner? My understanding is that there are two situations in Gado.

一. Consequences of excessive use

1. the appropriate dosage can achieve the desired effect. The proper dose will improve the effect. When the amount reaches a certain level, adding more may be counterproductive and cause unnecessary waste.

2. Over-add the prepared solution. How much sludge conditioner is appropriate, the early stage not only in the laboratory test, to find the right amount. It also needs to be verified in actual use in the field. During the operation, you can try to increase or decrease, adjust the amount of sludge conditioner added, observe the use effect, and determine the appropriate amount of addition.

二. Methods

1. One is that too much is added when preparing the sludge conditioner solution, and the other is that too much is added to the prepared solution. In either case, adding too much is a waste. There are pcorresponding ways to use coagulants. Generally, the proportion of preparation will be marked in it. There is usually no problem in following the recommended proportions.

The above is the sludge conditioner overdose and prevention methods, to find the appropriate dosage, but also need to adjust according to the production situation, the amount of waste water and sewage, wastewater changes, in terms of type, there is no bad sludge conditioner, the key is to choose whether the right. Under the premise of correct selection, the sludge conditioner should also be added and used appropriately, too much or too little can achieve the processing effect.