In addition to paying attention to the efficiency of the filter press, most of us are concerned about its operating costs, if the plate and frame filter press uses sludge dewatering agents properly, it can not only reduce the moisture content of the sludge, but also improve the mud press efficiency of the plate and frame filter press, and can save a large amount of operating costs from a long-term perspective. Today, Shijun New Materials Xiaobian will explain to you how the sludge conditioning agent can reduce the operating cost of the plate and frame filter press.

Works Chemical- Sludge conditioner, sludge dewatering synergist manufacturer

In the mud press of the plate and frame filter press, choosing a good sludge dewatering agent can not only effectively reduce the moisture content of the sludge, but also greatly improve the efficiency of the plate and frame filter press and save the cost of the operation plant! In the selection of sludge dewatering agents, Shijun New Material Xiaobian suggests that you can use sludge conditioning agents. Sludge conditioning agent is a kind of chemical agent which can change the surface structure of sludge, reduce the solid surface load of sludge, reduce the specific surface area of sludge and destroy the structure of bacteria.

The main components of sludge conditioning agents are inorganic compounds, sludge surface structure modifier, degreaser, wall breaking agent, sludge surface treatment agent, sludge stripping agent, etc. The sludge conditioning agent combined with the plate and frame mud press can reduce the sludge moisture content from more than 90% to 40%-60%, and fully realize the sludge reduction. At the same time reduce the operating costs of enterprises. I believe that many environmental protection people will ask, how much operating costs can we save after using sludge conditioning agents? So now please look down with Shijun new materials.

The following is a customer of a printing and dyeing factory. The customer has four 500-level high-pressure diaphragm plate and frame filter presses on site. The feed pressure is 0.8-0.9Mpa, and the press pressure is 1.2-1.4Mpa. When the pressing time (feed time 8-10h+ press time 3h+ sludge discharge time 1.5 hours) is more than 12 hours, the customer encountered the pain points of low mud pressing efficiency and high sludge disposal cost caused by high sludge moisture content. After the customer used sludge conditioning agents, the mud pressing efficiency was increased by 4 times, and the sludge moisture content was reduced to 38.2%.